Hired-hand Funnel Flow Fans: Cone Manuel d'utilisateur télécharger pdf

Funnel Flow Cone

Funnel Flow Fans

Hired-Hand Mfg., Inc. • 1733 Co Rd 68 • Bremen, Alabama 35033 • Phone 256-287-1000 • Fax 256-287-2000

Manual No. 4801-0163 rev 1-08 Page 1 of 1

Packing List for One (1) Unit

Three (3) Cone Sections Four (4) 5/16"x1 1/4" Bolts

Twenty Six (26) 5/16" Flat Washers Nine (9) 5/16"x7/8" Bolts

Thirteen (13) 5/16" Lock Nuts One (1) Wire Guard

One (1) Installation Manual

Directions

1. Check that all materials are present.

2. Remove the discharge side screen guard if present. Save the bolts and washers. You will need them

later.

3. Connect two sections together with three bolts three nuts and six washers and be sure that you place

washers on either side of the cone to minimize the chance of cracking the cone. DO NOT TIGHTEN

BOLTS COMPLETELY TIGHT.

4. Connect the third cone piece to the other two as you did in step 3 above. DO NOT TIGHTEN BOLTS

COMPLETELY TIGHT.

5. Mount the cone to the fan using the bolts

from step 2. Note the center of the top

section should be oriented as shown. Again

check that you placed a washer between the

bolt head, and the cone. Be sure that inside

of cone fits tight around orifice before

tightening section bolts.

6. Install the new wire guard in place at the end

of the cone. You should use the four

5/16"X1 1/4" bolts and eight 5/16" washers.

Funnel Flow Cone Funnel Flow Fans Hired-Hand Mfg., Inc. • 1733 Co Rd 68 • Bremen, Alabama 35033 • Phone 256-287-1000 • Fax 256-287-2000 Manua

Pas de commentaire

Hired-hand Funnel Flow Fans: Cone Manuel d'utilisateur